ProtoWizard Info Board Forum Index ProtoWizard Info Board
Revolutionizing the Jewelry Industry
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Same but different???
Goto page Previous  1, 2, 3
 
Post new topic   Reply to topic    ProtoWizard Info Board Forum Index -> New Conical Bit from Bits & Bits
View previous topic :: View next topic  
Author Message
kcgold



Joined: 10 Aug 2006
Posts: 449
Location: Menlo Park, CA
PostPosted: Thu Mar 05, 2009 12:19 pm    Post subject: Reply with quote
I put mine under the conical tools. Take the .005" - 10 degree tool, if that is your angle, and change the radius from 0.000" to 0.0025". That is all you need to do. Name the new tool and save it.

If you find that the side of the tool is leaving marks on the side of the model (chatter), increase the angle setting of the toll by a half of a degree and see if it helps.
Back to top
View user's profile Send private message
RandyChambers



Joined: 24 Jun 2006
Posts: 35
Location: Arlington TX
PostPosted: Thu Mar 05, 2009 8:13 pm    Post subject: Reply with quote
Fantastic!
Thanks so much, this board is very helpful!

Randy Chambers
Back to top
View user's profile Send private message Send e-mail Visit poster's website MSN Messenger
texasmiller



Joined: 15 Jul 2006
Posts: 145
PostPosted: Wed Mar 11, 2009 1:20 pm    Post subject: Re: toy Reply with quote
mhgjewel wrote:
i am not at liberty to say, but it is very very cool and will save us a boat load of time.

watch the web site he said he will post it there first

Matthew

Dual Spindle?
_________________
Regards,
Ken
http://www.3dcadjewelry.com
Back to top
View user's profile Send private message
kcgold



Joined: 10 Aug 2006
Posts: 449
Location: Menlo Park, CA
PostPosted: Wed Mar 11, 2009 4:37 pm    Post subject: Reply with quote
Yes, I think that is what he was referring to. Only works on the MDX-40.
Back to top
View user's profile Send private message
p schmidt



Joined: 18 Mar 2007
Posts: 906
Location: aurora IL
PostPosted: Tue Apr 07, 2009 8:56 am    Post subject: Reply with quote
hey orzel how's the new bits working?
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    ProtoWizard Info Board Forum Index -> New Conical Bit from Bits & Bits All times are GMT - 5 Hours
Goto page Previous  1, 2, 3
Page 3 of 3

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group