ProtoWizard Info Board

[Kai]

http://www.screencast.com/users/OlaviJing/folders/Jing/media/9a7ef4ec-695a-41c2-a797-d0f62bc2c3cf
Look at the video

The last time I made a mistake, whether even this abuse of the blade go to -0.96.

It goes too deep into the.

What is wrong?
Kai

[lemike]

Kai, in your video you have selected two times the same ring

when you check the toolpath and have a flat toolpath like on your video there is something wrong, restart the software (don't click on new, but close the re-open PW) and restart your operation

if you still have Z problem try this:
in Step 6 / Machine Zzero options, select top of material, then bottom of material, then use model zero, then calculate the toolpath, it used to work for me...

if it still not working on the mill side, you must do something wrong inside MachineWizard
_________________
MDX40 + CEAT Rorary
3Design 6.2
ProtoWizard 4
MachineWizard 3

[Kai]

Lemike Thank you for your advice, try them and they helped right away.

Again, I learned something new.

Yesterday I was really desperate when I could not understand that the program can do something like that.

Now it is all well again
Kai

[orzel67]

Ahh yes ,i over looked that possibility lol.remember to always close pw between every job

[jewelermdt]

I hope this is changed in the new PW. It's a PITA in my opinion, specially when wanting to do multiple section cutting.

Mike
_________________
jwx10/W dons rotary Rhino 4 RhinoGold - Machine Wizard